Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ref:elec03 [2018/04/23 15:49]
ixl2relax
techtalk:ref:elec03 [2019/08/14 23:26]
hippysmack
Line 6: Line 6:
 ===== Sub-Documents ===== ===== Sub-Documents =====
  
-* . . . [[techtalk:​ref:​elec03a|Battery vent tube clamps]]+* . . . [[techtalk:​ref:​elec03a|Battery vent tube clamps]] ​\\ 
 +* . . . [[techtalk:​ref:​elec03b|Moving the battery cables]] \\
  
 ---- ----
Line 130: Line 131:
  
 Shorai Batteries require a charging system output of 13.1 Volts or higher at idle, and must not exceed 15.2 volts at maximum output. Shorai Batteries require a charging system output of 13.1 Volts or higher at idle, and must not exceed 15.2 volts at maximum output.
 +
 +From the [[https://​shoraipower.com/​faq|Shorai website]]:
 +| **What about Water & Corrosion** - Avoid high pressure power washing around the battery case, or constant exposure to water. If the battery may be occasionally submerged, we highly suggest application of sealant to fill the horizontal seam between top and bottom of the battery case, and that the 5-pin port be fully packed with dielectric grease. (dielectric grease is a good idea in any case to insure no pin corrosion). Also, heavy grease should be liberally applied to terminals for wet environments. |
 +
 +| **What about Cold Weather Starting** - Down to about 20 degrees Fahrenheit (-7C) most users find that they can start normally on first crank. If your headlight comes on at key-ON, it is good for the batteries to flow some current before cranking in cold weather. The suggested headlight-on time before cranking depends on the temperature. If starting at 40F/5C, 30 seconds will help wake the battery and increase cranking performance. If at 0F/-17C, leave the lights on for 4~5 minutes before cranking. The result will be a better first crank, and longer battery life.  If the engine fails to start on first crank, that first crank has warmed the battery, and the second attempt will be much stronger. Other accessories that can be turned on before cranking can also be used for this purpose, such as heated gear, radio, etc... ​ Insuring that the battery is fully charged after storage also improves first-start performance in cold weather. |
  
 \\ \\
Line 140: Line 146:
  
 Here's a chart of alternative bulbs that can be used in place of 1157 Run/Turn or Run/Brake bulbs:\\ Here's a chart of alternative bulbs that can be used in place of 1157 Run/Turn or Run/Brake bulbs:\\
-{{:​techtalk:​ref:​elec:​1157-turnsignal-bulb-chart-specs.jpg?400|}}+{{:​techtalk:​ref:​elec:​1157-turnsignal-bulb-chart-specs.jpg|}}