Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:elec20 [2019/01/09 21:53] ixl2relax [Rear Turns] |
techtalk:ref:elec20 [2019/01/09 21:54] ixl2relax [Loose Turn Signal - Fixes] |
||
|---|---|---|---|
| Line 65: | Line 65: | ||
| \\ | \\ | ||
| - | ====== Loose Turn Signal - Fixes ====== | + | ===== Loose Rear Turn Signal - Fixes ===== |
| Some times the double-ended stud that mounts the rear turn signal housing to the fender (thru a stand-off spacer) is not long enough to get a good bite on the threads in the housing. That eventually leads to the first few threads stripping out. Even though there are more threads in the housing, the stud will not reach deep enough. | Some times the double-ended stud that mounts the rear turn signal housing to the fender (thru a stand-off spacer) is not long enough to get a good bite on the threads in the housing. That eventually leads to the first few threads stripping out. Even though there are more threads in the housing, the stud will not reach deep enough. | ||
