[[:techtalk:menu|{{  :techtalk:gototechnicalmenu.jpg|}}]]
====== REF: Engine Mechanicals - Sub-01G ======
====== Cam Bushing Removal ======

  * You can buy different brands but this is basically a slide hammer with an expandable collet.

|  Blind Hole Bearing Puller (Harbor Freight model) ((photo by Hippysmack))  |
|{{:techtalk:ref:tools:98_1200_cam_bushing_removal_2_by_hippysmack.jpg?direct&300|}}|

|  Decrease the width of the collet ((photo by Hippysmack))  |  Install it into and behind the bushing ((photo by Hippysmack))  |  Tighten the nuts to expand the collet ((photo by Hippysmack))  |
|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_5_by_hippysmack.jpg?direct&300|}}|

|  Hold outward pressure on the handle. Then yank the bushings out by knocking the slide against the handle end of the tool ((photos by Hippysmack))  |||
|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_6_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:tools:cam_bushing_installer_2_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:tools:cam_bushing_installer_1_by_hippysmack.jpg?direct&300|}}|

|The collet isn't wide enough to damage the case on \\ the way out ((photo by Hippysmack))|However, the chamfer inside the collet will damage \\ the bushing (L). Compare to new bushing on the right. ((photo by Hippysmack))|
|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:98_1200_cam_bushing_removal_8_by_hippysmack.jpg?direct&300|}}|


\\

[[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]]