REF: Engine Mechanicals - Sub-01G
Cam Bushing Removal
- You can buy different brands but this is basically a slide hammer with an expandable collet.
| Blind Hole Bearing Puller (Harbor Freight model) 1) |
 |
| Decrease the width of the collet 2) | Install it into and behind the bushing 3) | Tighten the nuts to expand the collet 4) |
 |  |  |
| Hold outward pressure on the handle. Then yank the bushings out by knocking the slide against the handle end of the tool 5) | ||
 |  |  |
| The collet isn't wide enough to damage the case on the way out 6) | However, the chamfer inside the collet will damage the bushing (L). Compare to new bushing on the right. 7) |
 |  |