Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:engmech01h [2018/09/19 03:18] hippysmack [Test Fitting Cams] |
techtalk:ref:engmech01h [2018/09/19 03:18] hippysmack [Test Fitting Cams] |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== REF: Engine Mechanicals - Sub-01H ====== | ====== REF: Engine Mechanicals - Sub-01H ====== | ||
====== Test Fitting Cams ====== | ====== Test Fitting Cams ====== | ||
- | Factory fitting of the cams is (or rather was) all about noise control. \\ | + | Factory fitting of the cams is (or rather was) all about noise control. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1840595)) \\ |
By selecting the cam gears sized specifically for the engine they were going in, they could walk that fine line between noisy and too-tight. \\ | By selecting the cam gears sized specifically for the engine they were going in, they could walk that fine line between noisy and too-tight. \\ | ||
The noise from the gears being a tad loose doesn't hurt anything. Too-tight however can cause localized tooth heating and failure. \\ | The noise from the gears being a tad loose doesn't hurt anything. Too-tight however can cause localized tooth heating and failure. \\ |