Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:engmech01h [2019/08/17 17:28] hippysmack [Lifters] |
techtalk:ref:engmech01h [2019/08/17 17:35] hippysmack [Lifter Bore O.D.] |
||
---|---|---|---|
Line 39: | Line 39: | ||
==== Lifter Bore O.D. ==== | ==== Lifter Bore O.D. ==== | ||
+ | Big cam lobes can hit against the lifter bore O.D. \\ | ||
+ | Below, the area where the cam lobe spins around was clearance using a sanding drum. \\ | ||
+ | Four plugs were made to go in the camshaft bushings to keep from hitting them with the die grinder. \\ | ||
+ | {{:techtalk:ref:engmech:clearancing_lifter_bore_od_1_by_grind.jpg?direct&170|}} ((photo by ~Grind~ of the XLFORUM http://xlforum.net/forums/showthread.php?t=1448694)) {{:techtalk:ref:engmech:clearancing_lifter_bore_od_2_by_grind.jpg?direct&170|}} ((photo by ~Grind~ of the XLFORUM http://xlforum.net/forums/showthread.php?t=1448694)) {{:techtalk:ref:engmech:clearancing_lifter_bore_od_3_by_grind.jpg?direct&170|}} ((photo by ~Grind~ of the XLFORUM http://xlforum.net/forums/showthread.php?t=1448694)) \\ | ||
==== Rocker Box ==== | ==== Rocker Box ==== | ||
See more on [[techtalk:evo:engmech04b#rocker_box_rocker_arm_inspection_and_servicing|Clearancing and inspecting the Rocker Boxes]] in the Sportsterpedia. \\ | See more on [[techtalk:evo:engmech04b#rocker_box_rocker_arm_inspection_and_servicing|Clearancing and inspecting the Rocker Boxes]] in the Sportsterpedia. \\ |