Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:engmech01i [2018/08/12 03:16] hippysmack [Installing Inner Cam Bushings (in the gear case)] |
techtalk:ref:engmech01i [2020/01/14 00:46] ixl2relax [REF: Engine Mechanicals - Sub-01L] |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Engine Mechanicals - Sub-01H ====== | + | ====== REF: Engine Mechanicals - Sub-01I ====== |
====== Installing Inner Cam Bushings (in the gear case) ====== | ====== Installing Inner Cam Bushings (in the gear case) ====== | ||
Line 7: | Line 7: | ||
Bushings are press fitted into the case. A press fit translates to the O.D. of the bushing being the same as the I.D. of the case bore (for practical purposes here). \\ | Bushings are press fitted into the case. A press fit translates to the O.D. of the bushing being the same as the I.D. of the case bore (for practical purposes here). \\ | ||
When a new bushing is pressed into the case bore, it's I.D is compressed and becomes distorted somewhat. \\ | When a new bushing is pressed into the case bore, it's I.D is compressed and becomes distorted somewhat. \\ | ||
- | The bushing in the gearcase is then reamed to the correct size and alignment to the cover bushings. | + | The bushing in the gearcase is then reamed to the correct size and alignment to the cover bushing. |