Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
techtalk:ref:engmech01i [2018/08/12 01:37] hippysmack created |
techtalk:ref:engmech01i [2020/01/14 00:46] (current) ixl2relax [REF: Engine Mechanicals - Sub-01L] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
| - | ====== REF: Engine Mechanicals - Sub-01H ====== | + | ====== REF: Engine Mechanicals - Sub-01I ====== |
| ====== Installing Inner Cam Bushings (in the gear case) ====== | ====== Installing Inner Cam Bushings (in the gear case) ====== | ||
| + | |||
| + | Per the FSM, each cam bushing installed in the gearcase must be positioned with the oiling slot at the exact top of the bore (12:00 position). ((HD XLH FSM pg 3-51)) \\ | ||
| + | |||
| + | Bushings are press fitted into the case. A press fit translates to the O.D. of the bushing being the same as the I.D. of the case bore (for practical purposes here). \\ | ||
| + | When a new bushing is pressed into the case bore, it's I.D is compressed and becomes distorted somewhat. \\ | ||
| + | The bushing in the gearcase is then reamed to the correct size and alignment to the cover bushing. | ||
| + | |||
