Differences
This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
techtalk:ref:engmech01p [2018/11/05 18:44] hippysmack created |
techtalk:ref:engmech01p [2018/11/05 18:56] hippysmack [Removing the Rivets on the Timing Inspection Cover] |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Removing the Rivets on the Timing Inspection Cover ====== | ====== Removing the Rivets on the Timing Inspection Cover ====== | ||
+ | | Drill the center of the rivets. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | Chisel off the head if it didn't fall off. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | | ||
+ | |{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_1_by_phillober.jpg?direct&300|}}|{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_2_by_phillober.jpg?direct&300|}}| | ||
+ | | Then lift the cover out. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | This second plate is in the back. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | | ||
+ | |{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_3_by_phillober.jpg?direct&300|}}|{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_4_by_phillober.jpg?direct&300|}}| | ||