Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:engmech01p [2018/11/05 18:44] hippysmack created |
techtalk:ref:engmech01p [2018/11/05 20:25] hippysmack [Removing the Rivets on the Timing Inspection Cover] |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== REF: Engine Mechanicals - Sub-01P ====== | ====== REF: Engine Mechanicals - Sub-01P ====== | ||
====== Removing the Rivets on the Timing Inspection Cover ====== | ====== Removing the Rivets on the Timing Inspection Cover ====== | ||
+ | Pop rivets were first installed on the timing cover on 1980 models to help prevent anyone (except the dealer) from tampering with the timing system. \\ | ||
+ | They were to be removed by the dealer for servicing the ignition and then replaced with new ones. \\ | ||
+ | Removal of the rivets are fairly simple. Just drill out the center of each one (which is the strength of the rivet). | ||
+ | The size drill bit used is not critical. It should be wider than the center hole of the rivet but not as wide as the rivet head O.D. \\ | ||
+ | The head may start spinning while you are drilling it. \\ | ||
+ | If that happens, just hold one end down with a screwdriver and continue drilling. \\ | ||
+ | Try not to drill too deep. \\ | ||
+ | Once the center has been drilled, sometimes the head will just fall off. \\ | ||
+ | If it doesn't, you can use a small screwdriver to pop it off. \\ | ||
+ | | Drill the center of the rivets. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | Chisel off the head if it didn't fall off. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | | ||
+ | |{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_1_by_phillober.jpg?direct&300|}}|{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_2_by_phillober.jpg?direct&300|}}| | ||
+ | |||
+ | | Then lift the cover out. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | This second plate is in the back. ((photo by Phillober of the XLFORUM http://xlforum.net/forums/showthread.php?t=1156460)) | | ||
+ | |{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_3_by_phillober.jpg?direct&300|}}|{{:techtalk:ref:engmech:removing_rivets_on_timing_cover_4_by_phillober.jpg?direct&300|}}| | ||