Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech01q [2019/02/18 05:35] hippysmack [Feuling lifters] |
techtalk:ref:engmech01q [2020/10/27 00:27] hippysmack [Roller end manuf. defect repair] |
||
---|---|---|---|
Line 88: | Line 88: | ||
The longer flats also allow higher lifts. | The longer flats also allow higher lifts. | ||
- | It seems aftermarket lifters have a tendency to be wide at the roller end. \\ | + | |
- | Measure them before installing to be sure they won't scratch the lifter bore when turned home. ((Hippysmack of the XLFORUM )) \\ | + | |
- | + | ||
===== Other Useful Links ===== | ===== Other Useful Links ===== | ||
This is a very good XLFORUM discussion thread on [[http://xlforum.net/forums/showthread.php?t=1933342&highlight=disassembling+lifters|lifters and high lift cams]]. \\ | This is a very good XLFORUM discussion thread on [[http://xlforum.net/forums/showthread.php?t=1933342&highlight=disassembling+lifters|lifters and high lift cams]]. \\ |