Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engmech01q [2019/02/18 16:52]
hippysmack [Roller end manuf. defect repair]
+++ techtalk:ref:engmech01q [2019/02/18 16:55]
hippysmack [Roller end manuf. defect repair]
@@ Line 117: / Line 117: @@
 |{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_8_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_11_by_hippysmack.jpg?direct&300|}}|
-The hone was turned by hand for app. 10 turns per lifter bore to clean up the scratches.
+The hone was turned by hand for app. 10 turns (while holding the bushing in place) per lifter bore to clean up the scratches.
 |{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_9_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_10_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:engmech:sizing_a_fueling_lifter_base_12_by_hippysmack.jpg?direct&300|}}|

Trace: