Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:ref:engmech01q [2020/10/27 00:27] hippysmack [Roller end manuf. defect repair] |
techtalk:ref:engmech01q [2024/01/14 18:24] hippysmack |
||
---|---|---|---|
Line 4: | Line 4: | ||
====== Tappet Flats ====== | ====== Tappet Flats ====== | ||
**This is in consideration of induced noise from the use of high lift cams**. \\ | **This is in consideration of induced noise from the use of high lift cams**. \\ | ||
- | The factory lifter is up to the job from the point of view of the hydraulics. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1510606&page=2)) \\ | + | The factory lifter is up to the job from the point of view of the hydraulics. ((aswracing of the XLFORUM https://www.xlforum.net/forum/vendors/hammer-performance/139198-well-been-doing-some-thinking-excess-valvetrain-noise/page2?t=1510606&page=2)) \\ |
However, the factory lifter's weaknesses are lack of available travel and less durable axle bearings. \\ | However, the factory lifter's weaknesses are lack of available travel and less durable axle bearings. \\ | ||
It's possible to machine the flat longer on a stock lifter. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=341901)) \\ | It's possible to machine the flat longer on a stock lifter. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=341901)) \\ |