Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:engmech01q [2019/02/18 17:15]
hippysmack [Roller end manuf. defect repair]
techtalk:ref:engmech01q [2019/02/18 17:57] (current)
hippysmack [Roller end manuf. defect repair]
Line 121: Line 121:
 The hone was turned by hand for app. 10 turns (while holding the bushing in place) per lifter bore to clean up the scratches. \\ The hone was turned by hand for app. 10 turns (while holding the bushing in place) per lifter bore to clean up the scratches. \\
 Due to the slanted bores, the bushing was raised slightly while honing. \\ Due to the slanted bores, the bushing was raised slightly while honing. \\
-|Hone held through center of pushrod hole. ((photo by Hippysmack))|This is all that was removed from all 4 bores \\ combined. ((photo by Hippysmack))|All scratches weren'​t removed but honing too much \\ would open the bore too far. ((photo by Hippysmack))|+|Hone held through center of pushrod hole. ((photo by Hippysmack))|This is all that was removed from all 4 bores \\ combined ​and from the bottom of the bores. ((photo by Hippysmack))|All scratches weren'​t removed but honing too much \\ would open the bore too far. ((photo by Hippysmack))|
 |{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_9_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_10_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_12_by_hippysmack.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_9_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_10_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​sizing_a_fueling_lifter_base_12_by_hippysmack.jpg?​direct&​300|}}|