Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:engmech01s [2019/05/21 20:51] hippysmack created |
techtalk:ref:engmech01s [2019/05/21 21:57] hippysmack [Windage Tray / Flywheel Scraper] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== REF: Engine Mechanicals - Sub-01S ====== | ====== REF: Engine Mechanicals - Sub-01S ====== | ||
| ====== Windage Tray / Flywheel Scraper ====== | ====== Windage Tray / Flywheel Scraper ====== | ||
| + | These are in two separate pieces. ((aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=203160))\\ | ||
| + | The scraper peels the oil off the flywheels and sends it down under the windage tray. \\ | ||
| + | The windage tray isolates the oil under the flywheels so that windage from the flywheels doesn't kick it back up again. \\ | ||
| + | |||
| + | The back end of the windage tray, where it meets the case and the scraper, has some half-moon style cutouts to allow scraped oil to go past. \\ | ||
| + | The front of the windage tray attaches to the factory windage barrier. \\ | ||
| + | It's basically an extension of the factory windage control. | ||
| + | |||
| + | The scraper needs to be .010" to .020" from the flywheels to work properly. \\ | ||
| + | The main thing is getting it all to fit, such that it works properly and the cases can be bolted back together without interference. \\ | ||
| + | Takes a little trial and error, bending, filing, checking, repeat. \\ | ||
| + | |||
| + | | XL engine flywheel scraper ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=203160)) | S&S engine w/ built in flywheel scraper ((photo by aswracing http://xlforum.net/forums/showthread.php?t=59421&page=28)) | | ||
| + | |{{:techtalk:ref:engmech:flywheel_scraper_by_aswracing.jpg?direct&300|}}|{{:techtalk:evo:oil:ss_wet_sumping_fix_by_aswracing.jpg?direct&300|}}| | ||
| + | |||
| \\ | \\ | ||
