Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:engmech02c [2021/07/20 00:57] hippysmack [Ring Gap Orientation] |
techtalk:ref:engmech02c [2024/01/14 21:00] hippysmack |
||
---|---|---|---|
Line 12: | Line 12: | ||
- | |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1572784&page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)| | + | |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/144923-piston-rings-76-ironhead/page2?t=1572784&page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)| |
- | |{{:techtalk:ref:engmech:ring_gap_positions_by_hippysmack.jpg?direct&400|}}|{{:techtalk:ref:engmech:AAAring_gap_positions_per_the_fsm_by_hippysmack.jpg?direct&400|}}| | + | |{{:techtalk:ref:engmech:ring_gap_positions_by_hippysmack.jpg?direct&400|}}|{{:techtalk:ref:engmech:ring_gap_positions_per_the_fsm_by_hippysmack.jpg?direct&400|}}| |