Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech02c [2018/09/01 02:36] hippysmack |
techtalk:ref:engmech02c [2019/11/14 06:43] hippysmack [Ring Gap Orientation] |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1572784&page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)| | |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1572784&page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)| | ||
| - | |{{:techtalk:ref:engmech:ring_gap_positions_by_hippysmack.jpg?direct&400|}}|{{:techtalk:ref:engmech:ring_gap_positions_by_the_fsm_by_hippysmack.jpg?direct&400|}}| | + | |{{:techtalk:ref:engmech:1ring_gap_positions_by_hippysmack.jpg?direct&400|}}|{{:techtalk:ref:engmech:1ring_gap_positions_by_the_fsm_by_hippysmack.jpg?direct&400|}}| |
