Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
techtalk:ref:engmech02c [2018/09/01 02:36]
hippysmack
techtalk:ref:engmech02c [2019/11/14 06:49] (current)
hippysmack [Ring Gap Orientation]
Line 13: Line 13:
  
 |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1572784&​page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)| |These are widely practiced ring gap locations during installation ((drawing by Hippysmack, gap locations by mikethebike61 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1572784&​page=2))|These gap positions are in the 2004 FSM via a drawing. ((04 Sportster FSM pg 3-56))((drawing by Hippysmack)). \\ However, specific rings notations are not (as they are below)|
-|{{:​techtalk:​ref:​engmech:​ring_gap_positions_by_hippysmack.jpg?​direct&​400|}}|{{:​techtalk:​ref:​engmech:​ring_gap_positions_by_the_fsm_by_hippysmack.jpg?​direct&​400|}}|+|{{:​techtalk:​ref:​engmech:​ring_gap_positions_by_hippysmack.jpg?​direct&​400|}}|{{:​techtalk:​ref:​engmech:​ring_gap_positions_per_the_fsm_by_hippysmack.jpg?​direct&​400|}}|