Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:engmech02d [2018/09/01 21:32] hippysmack [With the Head Off] |
techtalk:ref:engmech02d [2018/09/05 02:25] hippysmack [With the Head Off] |
||
|---|---|---|---|
| Line 37: | Line 37: | ||
| * Start with the piston in the bore (rings greased) but lowered down so the piston top is flush with the cylinder deck (if using dome piston) so you can submerge \\ the whole piston dome in measured fluid. | * Start with the piston in the bore (rings greased) but lowered down so the piston top is flush with the cylinder deck (if using dome piston) so you can submerge \\ the whole piston dome in measured fluid. | ||
| - | * Fasten a piece of plexiglas with a hole in one end (big enough for the burette spout) on top. \\ The hole should be at the high end of the plexiglase to allow air bubbles to escape thru the hole. \\ Tilt the cylinder on a incline have it so that a spirit level bubble is completely over to one edge. | + | * Fasten a piece of plexiglas with a hole in one end (big enough for the burette spout) on top. \\ The hole should be at the high end of the plexiglase to allow air bubbles to escape thru the hole. \\ Tilt the cylinder on a incline. Have it so that a spirit level bubble is completely over to one edge. |
| **Measure the Cylinder**: | **Measure the Cylinder**: | ||
