Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:engmech02f [2019/08/04 01:39]
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit]
techtalk:ref:engmech02f [2019/08/04 01:53] (current)
hippysmack [Installing Hammer Performance Billet Pushrod Base Kit]
Line 73: Line 73:
 |{{:​techtalk:​ref:​engmech:​hammerperf_rear_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_front_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}| |{{:​techtalk:​ref:​engmech:​hammerperf_rear_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​hammerperf_front_pushrod_tube_clearance_issue_by_donchicago48.jpg?​direct&​300|}}|
  
 +Also check that the cylinder base gasket isn't interfering with the pushrod tube base. ((DonChicago48 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1610587&​page=17)) \\
 +It could hang up on the gasket and potentially cause an oil leak. \\
 +You may have to trim the cylinder base gasket to clear the pushrod base retainer. \\
 +You can use the edge of the bottom gasket mating surface as a cutting guide. \\
 +With a sharp ExActo Knife, cut the gasket along the outline of the cylinder base edge. \\
  
 +|  Trimming the base gasket. ((DonChicago48 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1610587&​page=17)) ​ || 
 +|{{:​techtalk:​ref:​engmech:​trimming_axtell_base_gasket_1_by_donchicago48.jpg?​direct&​300|}}|{{:​techtalk:​ref:​engmech:​trimming_axtell_base_gasket_2_by_donchicago48.jpg?​direct&​300|}}|
  
   * Push the base down onto the case deck and hold pressure on the base with one hand.   * Push the base down onto the case deck and hold pressure on the base with one hand.