Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech03k [2019/07/21 00:38] hippysmack [Chopping OEM Sprocket Cover Into a Gothic Cross] |
techtalk:ref:engmech03k [2019/07/21 00:48] hippysmack [Chopping OEM Sprocket Cover Into a Gothic Cross] |
||
|---|---|---|---|
| Line 52: | Line 52: | ||
| {{:techtalk:ref:engmech:sprocket_cover_mod_22_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_23_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_24_by_anachris.jpg?direct&300|}} \\ | {{:techtalk:ref:engmech:sprocket_cover_mod_22_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_23_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_24_by_anachris.jpg?direct&300|}} \\ | ||
| - | {{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\ | + | A brass woven mesh sheet was cut as a backing the sprocket cover. \\ |
| + | (unpolished, mill finish, ASTM E2016-06, 12" width, 12" length, 0.025" wire diameter, 54% open area) \\ | ||
| + | |||
| + | Finished product: \\ | ||
| + | |||
| + | {{:techtalk:ref:engmech:sprocket_cover_mod_21_by_anachris.jpg?direct&200|}} {{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\ | ||
