Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:engmech03k [2019/07/21 00:48] hippysmack [Chopping OEM Sprocket Cover Into a Gothic Cross] |
techtalk:ref:engmech03k [2019/07/21 00:55] hippysmack [Chopping OEM Sprocket Cover Into a Gothic Cross] |
||
---|---|---|---|
Line 12: | Line 12: | ||
\\ | \\ | ||
+ | Total of about 48 hours. \\ | ||
Measurements taken with the graphic idea rough sketched. \\ | Measurements taken with the graphic idea rough sketched. \\ | ||
Line 35: | Line 36: | ||
{{:techtalk:ref:engmech:sprocket_cover_mod_13_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_14_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_15_by_anachris.jpg?direct&200|}} \\ | {{:techtalk:ref:engmech:sprocket_cover_mod_13_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_14_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_15_by_anachris.jpg?direct&200|}} \\ | ||
- | Total of about 48 hours. \\ | ||
The VHT wrinkle plus went on gloss (very gloss) with at least 3 coats at varying angles and given a couple of hours for the paint to set. \\ | The VHT wrinkle plus went on gloss (very gloss) with at least 3 coats at varying angles and given a couple of hours for the paint to set. \\ | ||
Then it was heated in the oven at 200 degrees. \\ | Then it was heated in the oven at 200 degrees. \\ | ||
Line 54: | Line 54: | ||
A brass woven mesh sheet was cut as a backing the sprocket cover. \\ | A brass woven mesh sheet was cut as a backing the sprocket cover. \\ | ||
(unpolished, mill finish, ASTM E2016-06, 12" width, 12" length, 0.025" wire diameter, 54% open area) \\ | (unpolished, mill finish, ASTM E2016-06, 12" width, 12" length, 0.025" wire diameter, 54% open area) \\ | ||
+ | |||
+ | {{:techtalk:ref:engmech:sprocket_cover_mod_21_by_anachris.jpg?direct&200|}} \\ | ||
Finished product: \\ | Finished product: \\ | ||
- | {{:techtalk:ref:engmech:sprocket_cover_mod_21_by_anachris.jpg?direct&200|}} {{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\ | + | {{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\ |