Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engmech04e [2019/10/28 03:23]
hippysmack [Testing from timing plug hole (57-03)]
+++ techtalk:ref:engmech04e [2020/08/08 04:14]
hippysmack [Building Your Own Slack Tube]
@@ Line 2: / Line 2: @@
 ====== REF: Engine Mechanicals - Sub-04E ======
 \\
-====== Building Your Own Slack Tube  ======
+====== Building Your Own Slack Tube (Manometer)  ======
 \\
 ====== Testing from timing plug hole (57-03) ======
@@ Line 18: / Line 18: @@
 The hole in a 5/16" stainless washer was enlarged to 5/8" to go up on the bushing. \\
 {{:techtalk:ref:engmech:timing_plug_adapter_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM http://xlforum.net/forums/showthread.php?t=1946516&page=4)) {{:techtalk:ref:engmech:homemade_slack_tube_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?p=5784790#post5784790))  {{:techtalk:ref:engmech:homemade_slack_tube_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?p=5784790#post5784790)) \\
+====== Building the Unit ======
 The slack tube below is made from 1/8" clear Tygon vinyl tubing and a 2x4 app 3 feet long. ((photo by Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?p=5784790#post5784790)) \\

Trace: