Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech05a [2019/07/16 15:11] hippysmack [Drag Specialties Breather Location Kit (EFI)] |
techtalk:ref:engmech05a [2019/07/16 15:12] hippysmack [Drag Specialties Breather Location Kit (EFI)] |
||
|---|---|---|---|
| Line 44: | Line 44: | ||
| ===== Drag Specialties Breather Location Kit (EFI) ===== | ===== Drag Specialties Breather Location Kit (EFI) ===== | ||
| - | Here is the OEM ham can without the filter. \\ | ||
| - | The two bolts on either side of it are the breather bolts that go into the heads. \\ | ||
| - | (and where the oil mist comes out). \\ | ||
| - | With the stock configuration, the mist is vented right back into the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11)) \\ | ||
| - | |{{:techtalk:ref:engmech:breather_mod_1_by_hagen.jpg?direct&300|}}| | ||
| |There are 3 holes for mounting the A/C & carb. \\ One on each head / one centered to the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Drag Specialties relocation kit. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | |There are 3 holes for mounting the A/C & carb. \\ One on each head / one centered to the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Drag Specialties relocation kit. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | ||
