Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech05a [2019/07/16 15:24] hippysmack [Drag Specialties Breather Location Kit (EFI)] |
techtalk:ref:engmech05a [2019/07/16 15:58] hippysmack [Drag Specialties Breather Location Kit (07-UP)] |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| - | ===== Drag Specialties Breather Location Kit (07-UP) ===== | ||
| - | The DS kit is in the right pic below plus gasket maker (not necessary) and Loctite. \\ | ||
| - | Bracket. \\ | ||
| - | Breather bolts. \\ | ||
| - | Banjo fittings and fiber washers. \\ | ||
| - | |There are 3 holes for mounting the A/C & carb. \\ One on each head / one centered to the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Drag Specialties relocation kit. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | ||
| - | |{{:techtalk:ref:engmech:breather_mod_3_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_4_by_hagen.jpg?direct&300|}}| | ||
| - | |||
| - | |||
| - | |Bracket and breather bolts installed. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Hoses run down under the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|NRHS backing plate hiding the assembly. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | ||
| - | |{{:techtalk:ref:engmech:breather_mod_5_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_6_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_7_by_hagen.jpg?direct&300|}}| | ||
| \\ | \\ | ||
