Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech05a [2019/07/16 15:24] hippysmack [Drag Specialties Breather Location Kit (EFI)] |
techtalk:ref:engmech05a [2019/07/18 04:00] hippysmack [Using Spark Plug Boot Connectors] |
||
---|---|---|---|
Line 42: | Line 42: | ||
|{{techtalk:ref:engmech:breather_mod_7_by_1200c.jpg?direct&300|}}| | |{{techtalk:ref:engmech:breather_mod_7_by_1200c.jpg?direct&300|}}| | ||
+ | ===== Vent Line Routing Pics ===== | ||
- | ===== Drag Specialties Breather Location Kit (07-UP) ===== | ||
- | The DS kit is in the right pic below plus gasket maker (not necessary) and Loctite. \\ | ||
- | Bracket. \\ | ||
- | Breather bolts. \\ | ||
- | Banjo fittings and fiber washers. \\ | ||
- | |There are 3 holes for mounting the A/C & carb. \\ One on each head / one centered to the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Drag Specialties relocation kit. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | ||
- | |{{:techtalk:ref:engmech:breather_mod_3_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_4_by_hagen.jpg?direct&300|}}| | ||
- | |||
- | |||
- | |Bracket and breather bolts installed. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|Hoses run down under the intake. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))|NRHS backing plate hiding the assembly. ((photo by Hagen of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=11))| | ||
- | |{{:techtalk:ref:engmech:breather_mod_5_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_6_by_hagen.jpg?direct&300|}}|{{:techtalk:ref:engmech:breather_mod_7_by_hagen.jpg?direct&300|}}| | ||
\\ | \\ |