Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech05c [2019/07/18 02:55] hippysmack [Installing a Catch Can on the Breather Vent Line] |
techtalk:ref:engmech05c [2019/07/18 02:59] hippysmack [Installing a Catch Can on the Breather Vent Line] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| This one is 4" long and 1-5/8" in dia. \\ | This one is 4" long and 1-5/8" in dia. \\ | ||
| + | The fittings can be installed however you like for your application (mounting position). \\ | ||
| + | Mounted vertically, (which is a more efficient use of it's volume) the drain valve can be installed on the bottom. \\ | ||
| + | Mounted horizontally, the drain valve can be installed on the side (which ends up being the bottom). \\ | ||
| + | |||
| | Breather Vent Catch Can. ((photo by Imaposer of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=18)) | | | Breather Vent Catch Can. ((photo by Imaposer of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=18)) | | ||
| |{{:techtalk:ref:engmech:catch_can_by_imaposer.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:catch_can_by_imaposer.jpg?direct&300|}}| | ||
