Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech05c [2019/07/18 02:55] hippysmack [Installing a Catch Can on the Breather Vent Line] |
techtalk:ref:engmech05c [2019/07/18 22:44] hippysmack [WD-40 Catch Can] |
||
---|---|---|---|
Line 5: | Line 5: | ||
This one is 4" long and 1-5/8" in dia. \\ | This one is 4" long and 1-5/8" in dia. \\ | ||
+ | The fittings can be installed however you like for your application (mounting position). \\ | ||
+ | Mounted vertically, (which is a more efficient use of it's volume) the drain valve can be installed on the bottom. \\ | ||
+ | Mounted horizontally, the drain valve can be installed on the side (which ends up being the bottom). \\ | ||
+ | |||
| Breather Vent Catch Can. ((photo by Imaposer of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=18)) | | | Breather Vent Catch Can. ((photo by Imaposer of the XLFORUM http://xlforum.net/forums/showthread.php?t=146084&page=18)) | | ||
|{{:techtalk:ref:engmech:catch_can_by_imaposer.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:catch_can_by_imaposer.jpg?direct&300|}}| | ||
- | ===== WD-40 Catch Can ===== | + | |
- | An old WD-40 can with the top cut out to drop the vent line into. \\ | + | |
- | The can vents to atmosphere. \\ | + | |
- | {{:techtalk:ref:engmech:catch_can_2_by_daytonasportster.jpg?direct&200|}} ((photo by DaytonaSportster of the XLFORUM http://xlforum.net/forums/showthread.php?t=72099&highlight=wet+sumping&page=27)) {{:techtalk:ref:engmech:catch_can_1_by_daytonasportster.jpg?direct&400|}} ((photo by DaytonaSportster of the XLFORUM http://xlforum.net/forums/showthread.php?t=72099&highlight=wet+sumping&page=27)) \\ | + | |
===== Homemade PCV Catch Can ===== | ===== Homemade PCV Catch Can ===== |