Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:engmech05d [2019/07/21 01:31] hippysmack [Line Routing] |
techtalk:ref:engmech05d [2019/07/21 02:23] hippysmack [Installing the Ultimate Crankcase Vent] |
||
---|---|---|---|
Line 101: | Line 101: | ||
|{{:techtalk:ref:engmech:04_up_crankcase_vent_21_by_deimus.jpg?direct&300|}}|{{:techtalk:ref:engmech:04_up_crankcase_vent_24_by_deimus.jpg?direct&300|}}|{{:techtalk:ref:engmech:04_up_crankcase_vent_26_by_deimus.jpg?direct&300|}}| | |{{:techtalk:ref:engmech:04_up_crankcase_vent_21_by_deimus.jpg?direct&300|}}|{{:techtalk:ref:engmech:04_up_crankcase_vent_24_by_deimus.jpg?direct&300|}}|{{:techtalk:ref:engmech:04_up_crankcase_vent_26_by_deimus.jpg?direct&300|}}| | ||
- | | Alternate way of making the baffle. ((photos by 60Gunner of the XLFORUM http://xlforum.net/forums/showthread.php?p=5763918#post5763918)) ||| | + | Alternate way of making the baffle: ((60Gunner of the XLFORUM http://xlforum.net/forums/showthread.php?p=5763918#post5763918)) \\ |
+ | The baffle should be pretty snug when installed. You should have to lift a little on one side then the other back and forth to remove it. \\ | ||
+ | The sheet metal was bent with my a small hand brake then the flaps were trimmed to fit. \\ | ||
+ | | 26 gauge sheet metal cut 2" wider than the cover length and trimmed for a tight fit. ((photos by 60Gunner of the XLFORUM http://xlforum.net/forums/showthread.php?p=5763918#post5763918)) ||| | ||
|{{:techtalk:ref:engmech:deimus_mod_1_by_60gunner.jpg?direct&250|}}|{{:techtalk:ref:engmech:deimus_mod_2_by_60gunner.jpg?direct&250|}}|{{:techtalk:ref:engmech:deimus_mod_3_by_60gunner.jpg?direct&250|}}| | |{{:techtalk:ref:engmech:deimus_mod_1_by_60gunner.jpg?direct&250|}}|{{:techtalk:ref:engmech:deimus_mod_2_by_60gunner.jpg?direct&250|}}|{{:techtalk:ref:engmech:deimus_mod_3_by_60gunner.jpg?direct&250|}}| | ||