Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engmech07s [2020/10/05 20:51]
hippysmack
+++ techtalk:ref:engmech07s [2020/11/01 00:19]
hippysmack [XR-750 8-Ball Breather Valve]
@@ Line 11: / Line 11: @@
 The 8-ball breather was designed to handle 45 cu. in. of volume. ((mrmom9r of the XLFORUM http://xlforum.net/forums/showthread.php?t=2041173&page=3)) \\
-Here is the breather hole in the rear of the crankcase where the 8-ball breather assembly is fitted. \\
+{{:techtalk:ref:engmech:8-ball_breather_valve_pic_2_by_davixlrtt.jpg?direct&300|}} ((photo by davixlrtt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5857958#post5857958)) {{:techtalk:ref:engmech:8-ball_breather_valve_pic_1_by_davixlrtt.jpg?direct&300|}} ((photo by davixlrtt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5857958#post5857958)) \\
+The first pic below shows the 3/4" tapped hole in the case behind the rear cylinder where the 8-ball breather assembly is fitted. \\
 {{:techtalk:ref:engmech:1972_xr-750_8-ball_breather_hole_in_case_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?p=4148222#post4148222)) {{:techtalk:ref:engmech:1972_xr-750_crankcase_breather_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM, cropped by Hippysmack http://xlforum.net/forums/showthread.php?t=2077883)) {{:gallery:iron:1972_xr-750_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM http://xlforum.net/forums/showthread.php?t=2077883)) \\

Trace: