Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:engmech07s [2020/10/07 00:12] hippysmack [XR-750 8-Ball Breather Valve] |
techtalk:ref:engmech07s [2020/11/01 00:19] hippysmack [XR-750 8-Ball Breather Valve] |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| The 8-ball breather was designed to handle 45 cu. in. of volume. ((mrmom9r of the XLFORUM http://xlforum.net/forums/showthread.php?t=2041173&page=3)) \\ | The 8-ball breather was designed to handle 45 cu. in. of volume. ((mrmom9r of the XLFORUM http://xlforum.net/forums/showthread.php?t=2041173&page=3)) \\ | ||
| + | |||
| + | {{:techtalk:ref:engmech:8-ball_breather_valve_pic_2_by_davixlrtt.jpg?direct&300|}} ((photo by davixlrtt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5857958#post5857958)) {{:techtalk:ref:engmech:8-ball_breather_valve_pic_1_by_davixlrtt.jpg?direct&300|}} ((photo by davixlrtt of the XLFORUM http://xlforum.net/forums/showthread.php?p=5857958#post5857958)) \\ | ||
| + | |||
| The first pic below shows the 3/4" tapped hole in the case behind the rear cylinder where the 8-ball breather assembly is fitted. \\ | The first pic below shows the 3/4" tapped hole in the case behind the rear cylinder where the 8-ball breather assembly is fitted. \\ | ||
