Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:genmsr01 [2019/09/05 16:38] ixl2relax [Starter Won't Turn Over] |
techtalk:ref:genmsr01 [2022/07/17 01:18] ixl2relax [Starter Won't Turn Over] |
||
---|---|---|---|
Line 78: | Line 78: | ||
- Starter Motor | - Starter Motor | ||
- | Obviously, to test at some of these points will require having the keyswitch on,\\ | + | Obviously, to test at some of these points will require having the Keyswitch ON,\\ |
the RUN/STOP switch in the RUN Mode and the Start Button pressed. | the RUN/STOP switch in the RUN Mode and the Start Button pressed. | ||
Line 113: | Line 113: | ||
**If all these have power, the motor should be turning.** | **If all these have power, the motor should be turning.** | ||
- | **As mentioned in the SP section on Voltages & Grounds, | + | **As mentioned in the [[techtalk:evo:elec01|SP section on Voltages & Grounds]], |
check all grounds in the system:** | check all grounds in the system:** | ||
Line 172: | Line 172: | ||
* CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle | * CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle | ||
* Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder | * Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder | ||
- | * Preferred Minimum 883=120psi - 1200=150psi (may be a little lower on cold engine) | + | * Preferred Minimum 883=120psi - 1200=150psi - 2004+ 1200=180psi (cold engine may be lower) |
* Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder | * Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder | ||
* Keep a record for later comparison | * Keep a record for later comparison |