Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:genmsr01 [2019/09/05 16:36] ixl2relax [Starter Won't Turn Over] |
techtalk:ref:genmsr01 [2020/10/30 21:37] ixl2relax [Basic Diagnosis - Won't Start] |
||
|---|---|---|---|
| Line 78: | Line 78: | ||
| - Starter Motor | - Starter Motor | ||
| - | Obviously, some of these tests points will require you to have the keyswitch on, the RUN/STOP switch in the RUN Mode and the Start Button pressed. | + | Obviously, to test at some of these points will require having the Keyswitch ON,\\ |
| + | the RUN/STOP switch in the RUN Mode and the Start Button pressed. | ||
| As a **quick test** to identify what part of the circuit\\ | As a **quick test** to identify what part of the circuit\\ | ||
| Line 171: | Line 172: | ||
| * CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle | * CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle | ||
| * Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder | * Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder | ||
| - | * Preferred Minimum 883=120psi - 1200=150psi (may be a little lower on cold engine) | + | * Preferred Minimum 883=120psi - 1200=150psi - 2004+ 1200=180psi (cold engine may be lower) |
| * Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder | * Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder | ||
| * Keep a record for later comparison | * Keep a record for later comparison | ||
