Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ref:genmsr01 [2019/09/05 16:37]
ixl2relax [Starter Won't Turn Over]
techtalk:ref:genmsr01 [2022/07/17 01:18]
ixl2relax [Starter Won't Turn Over]
Line 78: Line 78:
   - Starter Motor   - Starter Motor
  
-Obviously, to test at some of these points will require ​you to have the keyswitch on, the RUN/STOP switch in the RUN Mode and the Start Button pressed.+Obviously, to test at some of these points will require ​having ​the Keyswitch ON,\\ 
 +the RUN/STOP switch in the RUN Mode and the Start Button pressed.
  
 As a **quick test** to identify what part of the circuit\\ As a **quick test** to identify what part of the circuit\\
Line 112: Line 113:
 **If all these have power, the motor should be turning.** **If all these have power, the motor should be turning.**
  
-**As mentioned in the SP section on Voltages & Grounds,+**As mentioned in the [[techtalk:​evo:​elec01|SP section on Voltages & Grounds]],
 check all grounds in the system:** check all grounds in the system:**
  
Line 171: Line 172:
   * CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle   * CRITICAL - Manually Hold Carb Slide Open & Fully Twist Open Throttle
   * Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder   * Crank Engine about 5-7 cycles - Repeat procedure on Rear Cylinder
-  * Preferred Minimum 883=120psi - 1200=150psi (may be a little ​lower on cold engine)+  * Preferred Minimum 883=120psi - 1200=150psi ​- 2004+ 1200=180psi ​(cold engine ​may be lower)
   * Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder   * Having both Cold & Warm Readings can be helpful - Let engine completely cool - Take Reading on Each Cylinder
   * Keep a record for later comparison   * Keep a record for later comparison