Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:genmsr12 [2018/05/20 06:18] ixl2relax [REF: Shop Notes, Tips, and Tools] |
techtalk:ref:genmsr12 [2019/01/09 02:19] ixl2relax ↷ Links adapted because of a move operation |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Shop Notes and Tips ====== | + | ====== REF: General-MSR 12 ====== |
===== Cleaning Solutions ===== | ===== Cleaning Solutions ===== | ||
+ | |||
+ | |||
+ | ==== Carburetor Cleaner ==== | ||
+ | Carburetor cleaner is not just for cleaning carbs and their parts. \\ | ||
+ | A gallon of carburetor cleaner is very useful in cleaning most any parts, bolts and other metals and soaking stuck gaskets. \\ | ||
+ | There is a metal bucket with a handle inside so you can put in small parts and remove them with the handle easily without loosing any. \\ | ||
+ | Insert small parts, bolts, wrenches or whatever you need to clean, close the lid and let them soak. \\ | ||
+ | Later, open the lid, remove the small bucket inside by the handle, set the bucket on the ground and wash the parts cleaner off with a water hose. \\ | ||
+ | Let them air dry and most, if not all of the grease/grime should be gone. \\ | ||
+ | You may have to re-soak heavy grimed parts or use a wire brush to break grime hardened areas before soaking again. \\ | ||
+ | |||
+ | For soaking stuck gaskets between mated parts to loosen them, \\ | ||
+ | Depending on how old or how 'stuck' the parts are, soaking for a couple hours may help to separate the old gasket in between. \\ | ||
+ | Make sure to remove any rubber or plastic parts before soaking. \\ | ||
+ | Also check the label for safety precautions. \\ | ||
+ | Parts that have been sitting for years may have to be soaked for about 24 hours. \\ | ||
+ | |||
+ | | Carburetor Cleaner ((photo by Hippysmack)) ||| | ||
+ | |{{techtalk:ref:genmsr:parts_cleaner_1_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:genmsr:parts_cleaner_4.1_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:genmsr:parts_cleaner_3_by_hippysmack.jpg?direct&300|}}| | ||
+ | |||
+ | This oil pump had to be soaked overnite before the cover would separate from the body. \\ | ||
+ | Keep in mind, any rubber parts on the inside will have to be replaced before installation. \\ | ||
+ | | Soaking gaskets for more easy removal ((photos by Hippysmack)) ||| | ||
+ | |{{techtalk:ref:genmsr:parts_cleaner_4_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:genmsr:parts_cleaner_2_by_hippysmack.jpg?direct&300|}}|{{techtalk:ref:genmsr:parts_cleaner_5_by_hippysmack.jpg?direct&300|}}| | ||