Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:oil07 [2018/12/08 23:34] hippysmack [Media Type] |
techtalk:ref:oil07 [2019/11/14 16:26] hippysmack [Micron Ratings] |
||
---|---|---|---|
Line 111: | Line 111: | ||
+ | |||
+ | ====== Filter Fitment ====== | ||
+ | In April of 1995, the MoCo issued a Tech Tip stating: ((HD Technical Tips #42 dated April of 1995 pg 1)) \\ | ||
+ | When replacing oil filters during service intervals; \\ | ||
+ | Check that the oil filter adapter has a sufficient amount of threads protruding to properly engage the filter. \\ | ||
+ | The correct thread length should be 0.45"-0.52" \\ | ||
+ | |||
+ | The MoCo issued a Tech Tip on Oil Filter Fitment((HD Technical Tips #43 dated Sept of 1995)) \\ | ||
+ | Remember to check the oil filter adapter to ensure that it is tight. \\ | ||
+ | Any loose adapters should be removed, cleaned, threads coated with 242 Loctite and installed to correct thread height (as above) \\ | ||
+ | |||
+ | |||
+ | In September of 1995, the MoCo issued a Tech Tip on oil filter fitment. ((HD Technical Tips #43 dated Sept of 1995)) \\ | ||
+ | |||
+ | All OEM filters are interchangeable between the models (spin-ons). \\ (however we recommend that you use the appropriate filter for the model) \\ | ||
+ | But, there are some things to be aware of if filters are swapped between models. \\ | ||
+ | |||
+ | - Although Dyna models can use the short filter in place of the long filter, \\ The oiling system capacity would be reduced. | ||
+ | - Long filters cannot be used on EFI models because of the contact with the crankshaft position sensor. | ||
+ | - Eagle Iron oil filters are 1/4" longer than the stock filter. | ||
+ | On some models, you may run into a fitment problem. | ||
===== Filter Height ===== | ===== Filter Height ===== |