Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:oil07 [2019/02/06 04:24] hippysmack [Oil Filter Fitment] |
techtalk:ref:oil07 [2019/11/14 16:23] hippysmack [Micron Ratings] |
||
---|---|---|---|
Line 83: | Line 83: | ||
Micron comparison ((Drawing by Hippysmack, based on a drawing from Machinery Lubrication https://www.machinerylubrication.com/Read/30697/choose-oil-filter)) | Micron comparison ((Drawing by Hippysmack, based on a drawing from Machinery Lubrication https://www.machinerylubrication.com/Read/30697/choose-oil-filter)) | ||
- | {{:techtalk:ref:oil:micron_-_comparison_drawing_by_hippysmack.jpg?direct&300|}} | + | {{:techtalk:ref:oil:1micron_-_comparison_drawing_by_hippysmack.jpg?direct&300|}} |
* However, the micron rating is also now falsely used as a widespread measure of filtration efficiency. \\ (unintended purpose) \\ Here are some of the reasons why a micron rating is totally inappropriate for this use: ((see more here "Understanding Fluid Filter Rating (PDF)" https://www.fram.com/support/tech-documents/consumer-documents/)) | * However, the micron rating is also now falsely used as a widespread measure of filtration efficiency. \\ (unintended purpose) \\ Here are some of the reasons why a micron rating is totally inappropriate for this use: ((see more here "Understanding Fluid Filter Rating (PDF)" https://www.fram.com/support/tech-documents/consumer-documents/)) | ||
Line 113: | Line 113: | ||
====== Filter Fitment ====== | ====== Filter Fitment ====== | ||
+ | In April of 1995, the MoCo issued a Tech Tip stating: ((HD Technical Tips #42 dated April of 1995 pg 1)) \\ | ||
+ | When replacing oil filters during service intervals; \\ | ||
+ | Check that the oil filter adapter has a sufficient amount of threads protruding to properly engage the filter. \\ | ||
+ | The correct thread length should be 0.45"-0.52" \\ | ||
+ | |||
+ | The MoCo issued a Tech Tip on Oil Filter Fitment((HD Technical Tips #43 dated Sept of 1995)) \\ | ||
+ | Remember to check the oil filter adapter to ensure that it is tight. \\ | ||
+ | Any loose adapters should be removed, cleaned, threads coated with 242 Loctite and installed to correct thread height (as above) \\ | ||
+ | |||
+ | |||
In September of 1995, the MoCo issued a Tech Tip on oil filter fitment. ((HD Technical Tips #43 dated Sept of 1995)) \\ | In September of 1995, the MoCo issued a Tech Tip on oil filter fitment. ((HD Technical Tips #43 dated Sept of 1995)) \\ | ||