Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:oil10 [2019/08/17 23:15] hippysmack [Wet Sumping] |
techtalk:ref:oil10 [2020/05/08 01:14] hippysmack [Wet Sumping] |
||
|---|---|---|---|
| Line 26: | Line 26: | ||
| Acceleration is hampered until the oil clears the crank area. \\ | Acceleration is hampered until the oil clears the crank area. \\ | ||
| - | **Known causes of wet sumping during engine down time**: \\ | + | Engine oil sumping can be broken down into two catagories. \\ |
| + | 1. Wetsumping \\ | ||
| + | 2. Sit sumping \\ | ||
| + | |||
| + | **Known causes of wet sumping during engine operation**: \\ | ||
| + | * **Oil Line(s)**: | ||
| + | * An oil may be pinched / collapsed, or stopped up. \\ A blockage in the return line will not allow the scavenge pump to remove the oil from the sump or move it out fast enough to keep up with feed oil from the pump. | ||
| + | * On ironhead engines with the oil filter in the return line, a stopped up oil filter can hinder adequate oil flow out of the engine. | ||
| + | * A blockage in the vent line from the oil tank to the cam chest can prevent proper oil return pressure from going to the oil tank. | ||
| + | * **86-91 engine oil pressure regulator**: | ||
| + | * The discharge from the relief valve drains down into the gearcase. \\ Then that 'extra' oil and is routed to the crankcase sump through a hole in the case wall and gets pumped back to the tank. \\ The 'extra' oil adds volume to the sump, thus adds towards a wet sumping condition. \\ A weak spring or a bad seat at the plunger will cause the regulator to open more often and / or unnecessarily increasing the possibility of wet sumping while riding. | ||
| + | |||
| + | |1986-90 Oil Filter Mount ((photo Hippysmack of the XLFORUM))| | ||
| + | |{{:techtalk:evo:oil:86-90_oil_pressure_regulator_by_hippysmack.jpg?direct&300|}}| | ||
| + | |||
| + | ====== Sit Sumpimg ====== | ||
| + | |||
| + | **Known causes of sit sumping during engine down time**: \\ | ||
| This is simply oil from the tank draining slowly back down into the crankcase while the bike is parked for any length of time. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=518948&highlight=cam+chest+breather)) \\ | This is simply oil from the tank draining slowly back down into the crankcase while the bike is parked for any length of time. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=518948&highlight=cam+chest+breather)) \\ | ||
| When you start the engine, the excess oil in the crankcase is fired out the breather, onto the floor, (or into your air-filter on post-79 models). \\ | When you start the engine, the excess oil in the crankcase is fired out the breather, onto the floor, (or into your air-filter on post-79 models). \\ | ||
| Line 49: | Line 66: | ||
| |{{:techtalk:evo:oil:l87-90_check_ball_and_spring_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:l87-90_check_ball_and_spring_5_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:evo:oil:l87-90_check_ball_and_spring_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:l87-90_check_ball_and_spring_5_by_hippysmack.jpg?direct&300|}}| | ||
| - | |||
| - | **Known causes of wet sumping during engine operation**: \\ | ||
| - | * **Oil Line(s)**: | ||
| - | * An oil may be pinched / collapsed, or stopped up. \\ A blockage in the return line will not allow the scavenge pump to remove the oil from the sump or move it out fast enough to keep up with feed oil from the pump. | ||
| - | * On ironhead engines with the oil filter in the return line, a stopped up oil filter can hinder adequate oil flow out of the engine. | ||
| - | * A blockage in the vent line from the oil tank to the cam chest can prevent proper oil return pressure from going to the oil tank. | ||
| - | * **86-91 engine oil pressure regulator**: | ||
| - | * The discharge from the relief valve drains down into the gearcase. \\ Then that 'extra' oil and is routed to the crankcase sump through a hole in the case wall and gets pumped back to the tank. \\ The 'extra' oil adds volume to the sump, thus adds towards a wet sumping condition. \\ A weak spring or a bad seat at the plunger will cause the regulator to open more often and / or unnecessarily increasing the possibility of wet sumping while riding. | ||
| - | |||
| - | |1986-90 Oil Filter Mount ((photo Hippysmack of the XLFORUM))| | ||
| - | |{{:techtalk:evo:oil:86-90_oil_pressure_regulator_by_hippysmack.jpg?direct&300|}}| | ||
| - | |||
| - | |||
