Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:priclutch01 [2018/06/17 05:00] hippysmack [Removing the Magnets] |
techtalk:ref:priclutch01 [2018/06/17 05:01] hippysmack [Removing the Magnets] |
||
---|---|---|---|
Line 38: | Line 38: | ||
* A heat gun has been used successfully on the outside of the hub ((juzyHD of the XLFORUM http://xlforum.net/forums/showthread.php?t=2000061&highlight=splines+hub)) adjacent to each magnet removed. | * A heat gun has been used successfully on the outside of the hub ((juzyHD of the XLFORUM http://xlforum.net/forums/showthread.php?t=2000061&highlight=splines+hub)) adjacent to each magnet removed. | ||
- | * A torch (propane or whatever) should work better and faster. However, don't get it too hot or the magnet and the properties thereof could be ruined. Use a big screwdriver or small pry bar to LIGHTLY PRY the magnets loose or you will break them. TAKE YOUR TIME !!! ((Vanmor of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666986&highlight=stator+repair)) | + | * A torch (propane or whatever) should work better and faster. However, don't get it too hot or the magnet and the properties thereof could be ruined. \\ Use a big screwdriver or small pry bar to LIGHTLY PRY the magnets loose or you will break them. TAKE YOUR TIME !!! ((Vanmor of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666986&highlight=stator+repair)) |
* You can put it in an oven at 400*, you want to heat it evenly as spot heating can cause distortion. The magnets are brittle so be careful. ((bustert of the XLFORUM http://xlforum.net/forums/showthread.php?t=2000061&highlight=splines+hub&page=2)) | * You can put it in an oven at 400*, you want to heat it evenly as spot heating can cause distortion. The magnets are brittle so be careful. ((bustert of the XLFORUM http://xlforum.net/forums/showthread.php?t=2000061&highlight=splines+hub&page=2)) | ||