Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:svcproc11 [2021/08/22 16:17] hippysmack [Sub-Documents] |
techtalk:ref:svcproc11 [2021/08/22 18:33] hippysmack [Sub-Documents] |
||
---|---|---|---|
Line 11: | Line 11: | ||
===== Sub-Documents ===== | ===== Sub-Documents ===== | ||
* [[techtalk:ref:svcproc11a|98 1200S 5 Speed Transmission Inspection]] | * [[techtalk:ref:svcproc11a|98 1200S 5 Speed Transmission Inspection]] | ||
- | * [[techtalk:ref:svcproc11b|]] | + | * [[techtalk:ref:svcproc11h|Known 1991-2003 Transmission Wear]] |
- | * [[techtalk:ref:svcproc11c|]] | + | * [[techtalk:ref:svcproc11b|Setting 1991-2003 Shift Pawl Position]] |
- | * [[techtalk:ref:svcproc11d|]] | + | * [[techtalk:ref:svcproc11c|Why There is So Much Slop in the 1991-2003 Shifter Shaft]] |
- | * [[techtalk:ref:svcproc11e|]] | + | * [[techtalk:ref:svcproc11d|What Causes the 1991-2003 Shifter Detent Plate to Lean]] |
- | * [[techtalk:ref:svcproc11f|]] | + | * [[techtalk:ref:svcproc11e|What Causes the 1991-2003 Shift Drum Pins to Walk Out of the Drum]] |
- | * [[techtalk:ref:svcproc11g|]] | + | * [[techtalk:ref:svcproc11f|What Causes the 1991-2003 Shift Arm to Scrub the Starter Gear]] |
+ | * [[techtalk:ref:svcproc11g|1991-2003 Shifter Detent Plate Retaining Ring Alternatives]] | ||