Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:svcproc16 [2019/02/23 02:38]
hippysmack [Mechanical]
+++ techtalk:ref:svcproc16 [2020/04/25 18:55]
hippysmack [Assembly]
@@ Line 48: / Line 48: @@
 |{{:techtalk:ref:svcproc:lifter_inspect_6_by_hippysmack.jpg?direct&300|}}|
 ===== Assembly =====
+There is a small amount of pressure on the hydraulic lifter plunger holding the top retainer clip in place on a dry lifter. \\
+It can be pushed down with your finger to install the clip. \\
+But with a lifter half or more full of oil, it's harder to work the plunger with your fingers as the pressure behind the plunger is greater. \\
+If you install the lifter into a holder, that frees up both hands and gives better leverage on the plunger. \\
+The holder below is fabbed from a steel sheet and a welded bushing to hold the lifter. \\
+A 2x4 block of wood with a 1" hole drilled into it can also be used to hold the lifter. \\
+Below is a fabbed steel holder. \\
+The block is used to press the plunger down. A spare pushrod or screwdriver can also be used to depress the plunger.
+{{:techtalk:ref:tools:lifter_holding_tool_2_by_ngot8r.jpg?direct&300|}} ((photo by NGOT8R of the XLFORUM http://xlforum.net/forums/showthread.php?t=2076454&page=4))
 |{{:techtalk:ref:svcproc:lifter_assembly_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_4_by_hippysmack.jpg?direct&300|}}|

Trace: