Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ref:svcproc9l [2024/04/30 21:22] hippysmack [Carrier 1] |
techtalk:ref:svcproc9l [2024/05/01 17:26] hippysmack ↷ Page name changed from techtalk:ref:svcproc9g to techtalk:ref:svcproc9l |
||
|---|---|---|---|
| Line 457: | Line 457: | ||
| * Dr Dick: The rivets are actually precision pins that you peen both ends. There is no rivet head. Rivet was a terrible choice of word on my part. These pins are already installed in the trock tower. | * Dr Dick: The rivets are actually precision pins that you peen both ends. There is no rivet head. Rivet was a terrible choice of word on my part. These pins are already installed in the trock tower. | ||
| + | Here is the 1977-1985 tower. Changed for clearance of the 1977 up shifter shaft that came in from the left. \\ | ||
| + | {{:techtalk:ref:svcproc:htbs_1977-1985_shift_tower_by_dr_dick.jpg?direct&600|}} \\ | ||
| + | |||
| + | And here is the old trock cast iron tower, by far the best shift fork control and never breaks. Best of both worlds. \\ | ||
| + | {{:techtalk:ref:svcproc:htbs_trock_cast_iron_tower_by_dr_dick.jpg?direct&600|}} \\ | ||
| ====== Shift Shaft ====== | ====== Shift Shaft ====== | ||
| To this point, we have talked about each part (with the exception of the centering springs and the tower) and how it interacts with its mates. It's time to carry this a bit farther from the workbench. \\ | To this point, we have talked about each part (with the exception of the centering springs and the tower) and how it interacts with its mates. It's time to carry this a bit farther from the workbench. \\ | ||
