Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:ref:tools026 [2020/05/22 23:29] hippysmack [Field Calibration] |
techtalk:ref:tools026 [2020/05/24 03:14] hippysmack [Field Calibration] |
||
---|---|---|---|
Line 112: | Line 112: | ||
- **Repeat this calibration procedure until you get the wrench to click on the length mark as in the test check above**. | - **Repeat this calibration procedure until you get the wrench to click on the length mark as in the test check above**. | ||
- | {{:techtalk:ref:tools:torque_wrench_calibration_15_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:torque_wrench_calibration_16_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:torque_wrench_calibration_17_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:torque_wrench_calibration_15_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:torque_wrench_calibration_160_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:torque_wrench_calibration_17_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
On the test wrench, the bushing was turned counterclockwise originally and the wrench clicked even farther toward the handle end once tested. \\ | On the test wrench, the bushing was turned counterclockwise originally and the wrench clicked even farther toward the handle end once tested. \\ |