Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:tools101 [2022/03/23 20:12] hippysmack [Primary and Cam / Gearcase Cover Removal] |
techtalk:ref:tools101 [2022/03/23 21:14] (current) hippysmack |
||
---|---|---|---|
Line 30: | Line 30: | ||
This prompts some to change the screws out to modern hex (allen) head socket screws. \\ | This prompts some to change the screws out to modern hex (allen) head socket screws. \\ | ||
Even allen head screws won't take a lot of over-torque without distorting the drive slots in the head though. \\ | Even allen head screws won't take a lot of over-torque without distorting the drive slots in the head though. \\ | ||
- | For the most even tightening of any of these screws, you can use torque wrench with the correct bits. \\ | + | For the most even tightening of any of these screws, you can use a torque wrench with the correct bits. \\ |
You can find hex bits at hardware / tool stores that are either made to socket wrench adapters or made to insert into them. \\ | You can find hex bits at hardware / tool stores that are either made to socket wrench adapters or made to insert into them. \\ | ||
Line 37: | Line 37: | ||
The pic below shows a 0-80 in/lb torque wrench with adapters for a flat head screw. Just use the correct hex bit needed. \\ | The pic below shows a 0-80 in/lb torque wrench with adapters for a flat head screw. Just use the correct hex bit needed. \\ | ||
- | {{:techtalk:ref:tools:torque_wrench_with_hex_bit_adapter_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:torque_wrench_with_hex_bit_adapters_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
===== Primary Cover ===== | ===== Primary Cover ===== | ||
- | + | \\ | |
- | + | ||
===== Cam / Gearcase Cover ===== | ===== Cam / Gearcase Cover ===== | ||