Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools103 [2019/05/21 17:59] hippysmack [Steel angle fixture] |
techtalk:ref:tools103 [2019/05/26 23:29] hippysmack xlforum |
||
---|---|---|---|
Line 79: | Line 79: | ||
|Here is another way to true flywheels in a small Myford lathe that has only a 4.5" swing that won't fit Harley flywheels. \\ Two offset pieces made from some flat half-inch thick bar and some half-inch round bar.||| | |Here is another way to true flywheels in a small Myford lathe that has only a 4.5" swing that won't fit Harley flywheels. \\ Two offset pieces made from some flat half-inch thick bar and some half-inch round bar.||| | ||
^ **Truing flywheels on center in a lathe via offset jigs** ((photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) ^^^ | ^ **Truing flywheels on center in a lathe via offset jigs** ((photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) ^^^ | ||
+ | |||
+ | |{{:techtalk:ref:tools:truing_flywheels_in_a_lathe_by_aussiegazz.jpg?direct&300|}}| | ||
+ | ^ **Truing flywheels on center in a lathe with \\ no offset jigs** ((photo by AussieGazza of the XLFORUM http://xlforum.net/forums/showthread.php?t=692835&page=9)) ^ | ||
+ | |||
===== Crankshaft / Flywheel Installation ===== | ===== Crankshaft / Flywheel Installation ===== | ||