Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:tools103 [2019/05/21 17:59]
hippysmack [Steel angle fixture]
techtalk:ref:tools103 [2019/05/26 23:29] (current)
hippysmack xlforum
Line 79: Line 79:
 |Here is another way to true flywheels in a small Myford lathe that has only a 4.5" swing that won't fit Harley flywheels. \\ Two offset pieces made from some flat half-inch thick bar and some half-inch round bar.||| |Here is another way to true flywheels in a small Myford lathe that has only a 4.5" swing that won't fit Harley flywheels. \\ Two offset pieces made from some flat half-inch thick bar and some half-inch round bar.|||
 ^  **Truing flywheels on center in a lathe via offset jigs** ((photos by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ ^^^ ^  **Truing flywheels on center in a lathe via offset jigs** ((photos by Hopper of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=395586)) ​ ^^^
 +
 +|{{:​techtalk:​ref:​tools:​truing_flywheels_in_a_lathe_by_aussiegazz.jpg?​direct&​300|}}|
 +^  **Truing flywheels on center in a lathe with \\ no offset jigs** ((photo by AussieGazza of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=692835&​page=9)) ​ ^
 +
 ===== Crankshaft / Flywheel Installation ===== ===== Crankshaft / Flywheel Installation =====