Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools104 [2018/05/21 07:49] ixl2relax [REF: Tools - Sub-004] |
techtalk:ref:tools104 [2020/03/01 04:20] hippysmack [Gaskets] |
||
---|---|---|---|
Line 4: | Line 4: | ||
====== Heads ====== | ====== Heads ====== | ||
+ | |||
+ | ===== Gaskets ===== | ||
+ | |||
+ | If you are using MLS head gaskets, you need to test fit them with the heads on to make sure the rivets don't get sandwiched under the head surface. \\ | ||
+ | Snug the bolts down lightly, and check the rivets holding the gasket together, you can see them in the pics below. \\ | ||
+ | You want to be sure they are not trapped between the head and cylinder deck. \\ | ||
+ | |||
+ | If you need to, you can remove the rivets with a Dremil rotary tool with the metal cutting blade. \\ | ||
+ | You just have to go slow and cautious not to cut into the gasket. \\ | ||
+ | |||
+ | {{:techtalk:ref:tools:mls_rivets_1_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?t=1422877&page=8)) {{:techtalk:ref:tools:mls_rivets_2_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?t=1422877&page=8)) {{:techtalk:ref:tools:removing_head_gasket_rivets_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
====== Valves ====== | ====== Valves ====== | ||
===== Valve Spring Compressor ==== | ===== Valve Spring Compressor ==== |