Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:tools113 [2018/05/20 06:09] ixl2relax [REF: Shop Notes, Tips, and Tools - Sub-03M] |
techtalk:ref:tools113 [2018/05/21 07:53] ixl2relax [REF: Tools - Sub-013] |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Tools - Sub-013 ====== | + | ====== REF: Tools - 113 ====== |
====== Wheel Truing / Balancing ====== | ====== Wheel Truing / Balancing ====== | ||
- | |{{:techtalk:ref:notes:wheel_truing_stand_1_by_hopper.jpg?direct&300|}}|{{:techtalk:ref:notes:wheel_truing_stand_2_by_hopper.jpg?direct&300|}}| | + | |{{techtalk:ref:tools:wheel_truing_stand_1_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_stand_2_by_hopper.jpg?direct&300|}}| |
| $5 wheel truing stand ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | For balancing, use old worn wheel bearings, not \\ notchy, with WD40 for lube. Nice free movement. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | | | $5 wheel truing stand ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | For balancing, use old worn wheel bearings, not \\ notchy, with WD40 for lube. Nice free movement. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | | ||
- | |{{:techtalk:ref:notes:wheel_truing_3_by_hopper.jpg?direct&300|}}|{{:techtalk:ref:notes:wheel_truing_4_by_hopper.jpg?direct&300|}}| | + | |{{techtalk:ref:tools:wheel_truing_3_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_4_by_hopper.jpg?direct&300|}}| |
|For lacing: To get the initial spoking nice and centered, drill a hole on your work bench for the axle, \\ scribe a circle where the rim goes and locate it with wooden blocks screwed to the bench. \\ Wooden shims provide the correct offset. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))|| | |For lacing: To get the initial spoking nice and centered, drill a hole on your work bench for the axle, \\ scribe a circle where the rim goes and locate it with wooden blocks screwed to the bench. \\ Wooden shims provide the correct offset. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))|| | ||