Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
techtalk:ref:tools113 [2018/05/21 07:53] ixl2relax [REF: Tools - Sub-013] |
techtalk:ref:tools113 [2024/01/23 04:15] hippysmack |
||
---|---|---|---|
Line 4: | Line 4: | ||
|{{techtalk:ref:tools:wheel_truing_stand_1_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_stand_2_by_hopper.jpg?direct&300|}}| | |{{techtalk:ref:tools:wheel_truing_stand_1_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_stand_2_by_hopper.jpg?direct&300|}}| | ||
- | | $5 wheel truing stand ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | For balancing, use old worn wheel bearings, not \\ notchy, with WD40 for lube. Nice free movement. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | | + | | $5 wheel truing stand ((photo by Hopper of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/63858-special-tools?t=395586)) | For balancing, use old worn wheel bearings, not \\ notchy, with WD40 for lube. Nice free movement. ((photo by Hopper of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/63858-special-tools?t=395586)) | |
|{{techtalk:ref:tools:wheel_truing_3_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_4_by_hopper.jpg?direct&300|}}| | |{{techtalk:ref:tools:wheel_truing_3_by_hopper.jpg?direct&300|}}|{{techtalk:ref:tools:wheel_truing_4_by_hopper.jpg?direct&300|}}| | ||
- | |For lacing: To get the initial spoking nice and centered, drill a hole on your work bench for the axle, \\ scribe a circle where the rim goes and locate it with wooden blocks screwed to the bench. \\ Wooden shims provide the correct offset. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))|| | + | |For lacing: To get the initial spoking nice and centered, drill a hole on your work bench for the axle, \\ scribe a circle where the rim goes and locate it with wooden blocks screwed to the bench. \\ Wooden shims provide the correct offset. ((photo by Hopper of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/63858-special-tools?t=395586))|| |