Table of Contents
This is an old revision of the document!
REF: Tools - 115
Clutch Hub / Spring Compressor Tools
4 Speed
 |  |
| 4 Speed Clutch Hub Tools 1) | |
 |  |
| Clutch Hub Tool 2) | |
| Two pieces of timber screwed together, some 1/4“ UNC threaded rod, 1/4” nuts and washers. It does not have the center screw like the factory tool. Just tighten down the nuts on the threaded rod to compress the clutch springs. 3) | This one uses an auto harmonic balancer puller as a center torque shaft | |
 |  |  |
| Clutch spring compressor 4) | Clutch spring compressor 5) | Clutch spring compressor 6) |
5 Speed (1991-later)
There are a number of ways to accomplish the compression of the Clutch Diaphragm Spring.
3“ PVC cap w/ 5/16”x24 bolt or all-thread, coupler, nut and washer.
9) 
10)
And here are a couple commercial products:
2)
photos by arkyboy of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=6
3)
Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586
4)
photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586
5)
photo by IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?threadid=2023217
6)
photo by Tribulation of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=18
7)
photos by Dirty Don of the XLFORUM http://xlforum.net/forums/showthread.php?threadid=1608837
8)
photos by Jt1200r of the XLFORUM http://xlforum.net/forums/showthread.php?t=49915&page=14
9)
photo by trainman of the XLFORUM
10)
photo by DaytonaSportster of the XLFORUM http://xlforum.net/forums/showthread.php?t=1742779
